Panoramic photo robot with Bluetooth control, based on Arduino MEGA 2560
Since everything in this schematic is either public or super simple I leave it as public too.
**NOT for commercial use!**
This project of mine has just been started so there is no firmware nor software (PC, Android) available yet. Currently I don't plan to make it public like the Arduino shield design.
If you like the s...
This project is rework Schematics and PCB 3D Wire Bending Machine from [howtomechatronics](https://howtomechatronics.com/projects/arduino-3d-wire-bending-machine/), where it is described how to work with the board and how to program it, including the source code for arduino.
***Because this board can be used for any different control of three stepper motors with Arduino, it will certainly find us...
Compact board for interacting with stepper drivers and compact enough to be incorporated into your great things
* Provide 5V directly or place 12-48V regulator
* Ferrite beads (short FB pads and remove 1nf cap)
* Xtal and caps
* High voltage regulator (U4 + caps)
* LED, test points
This is a Stepper HAT for Raspberry Pi or stand-alone use. It is the board I'm currently using in my SandBot [SandBot](https://robdobson.com/2018/08/a-new-sandbot/) and provides two SilentStepStick TMC2100 positions, two FET drivers for LED light strip or similar and two servo ports. Software is here: [RBotFirmware](https://github.com/robdobsn/RBotFirmware)
Demonstrating simulations of a DC and a two phase stepper motor.
#### Model of a generic DC motor.
The model has the motor positive and negative power supply terminals.
It also has three outputs.
TORQUE is a voltage representing the motor torque scaled as 1V/Nm.
ANGVEL is a voltage representing the angular velocity of the motor scaled as 1V/RADIAN/s.
POSITION is a voltage...
Please refer to Dr. Scott M. Baker's blog below.
Home ∕ Electronics Projects ∕ Z80 Retrocomputing 5 – Single Stepper for RC2014
I'm very interested with the Dr. Scott's project TIL311 Bus Monitor Board and this Step Executor Board.
This time I'd like to make this board with my favorite parts like pod with tab control, alternate Toggle switch for single stepper.
Therefore I decided to make my own...
4 steppers direct ESP32 GPIO and 2 via I2S shift register
shift register PWM for 4 mosfet, 4 servo outputs
mixed voltage: two power rails
current and voltage monitor for two power rails and IC power
all parts available through lscs.com
I2C OLED and output for TFT+touch
A stepped-motor controller for three steppers using Trinamics 2130 compatible "SilentStepSticks". Also supports upto two hobby servos and has two power FETs for on/off control of loads (including inductive ones).
Can be used stand-alone using the ESP32 on-board which supports WiFi and a web-based UI when running the [companion software called RBotFirmware](https://github.com/robdobsn/RBotFirmware)...
Our website uses essential cookies to help us ensure that it is working as expected, and uses optional analytics cookies to offer you a better browsing experience. To find out more, read our Cookie Notice