A simple ethernet shield for Wemos D1 Mini based on W5500 respecting WizNet directives (https://wizwiki.net/wiki/doku.php/products:w5500:start).
All SMD components are chosen such that JLCPCB can mount them. The only exception is the crystal; replace it with X322525MOB4SI (adapting both schematic and layout) if you want it mounted.
Since JLCPCB can mount either top or bottom only, all the SMD co...
Hi guys, Etherduino is an Arduino board with Ethernet module embedded in it, the microcontroller used is ATMega328, the board also contains dual I/O lines in which one line can be of female headers and the other of right-angled header pins for convenience of attaching the wires to the board even when the board is connected to shields.
Second iteration. First version worked fine but decided I needed a factory reset switch and LED's moving to end of PCB.
Designed to fit exactly in "VG-AL53" aluminium enclosure (google it) these are about $7 on aliexpress.
Works with Microchip TCP Lite stack. Firmware is very close but not yet complete.
I have attached the MPLABX XC8 project in a semi-working state below. Basically it is...
## ETHERNET INTERFACE BRICK AND SHIELD ##
Your Ethernet Shield gets a total renewal now! This shield provides you instant Internet connectivity with a high spec Ethernet controller, W5200, with twice the buffer size of v1.0 and support for up to eight simultaneous TCP/UDP connections. An included SD slot enables applications that require storing large amounts of data, like IoT data logging. Thank...
Power Plug remote control via LAN
Relay D2 "0" - enable, "1" - disable
Current sensor - A0
LED Green D30 "1" - enable, "0" - disable
LED Red D31 "1" - enable, "0" - disable
Relay D3 "0" - enable, "1" - disable
Current sensor - A1
LED Green D32 "1" - enable, "0" - disable
LED Red D33 "1" - enable, "0" - disable
Relay D5 "0" - enable, "1" - disable
Current sensor - A2
ESP32-WROOM-32 is a powerful, generic Wi-Fi+BT+BLE MCU module that targets a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding.
At the core of this module is the ESP32-D0WDQ6 chip*. The chip embedded is designed to be scalable and adaptive. There are two CPU cores that can be individu...
This is an automatic Cat6 / Cat5 network cable tester designed using NE555 timer and 4017 decade counters. This unit test all 8 wire lines of twisted pair network cable and indicate pass/fail status with single LED.
We design this unit to test network connectivity issues in Cat6 / Cat5 cable systems and it is capable to check both crossover and straight-through type network cables.
Our website uses essential cookies to help us ensure that it is working as expected, and uses optional analytics cookies to offer you a better browsing experience. To find out more, read our Cookie Notice