Universal useable MiniPill with LoRa capability
Using STM32L051C8T6 chip
Version 1.2: R2 to GND instead of VCC
for more information visit [https://www.iot-lab.org/blog/370/](https://www.iot-lab.org/blog/370/)
<p>The device is based on the RF-Star wireless module and includes an CC2652RB (ARM Cortex M4F) RF microcontroller supporting the following protocols: Thread, Zigbee®, Bluetooth® 5.1 Low Energy, IEEE 802.15.4, IPv6-enabled (6LoWPAN), as well as proprietary protocols including TI 15.4-Stack (2.4 GHz), and simultaneous multi-protocol operation via Dynamic Multiprotocol Manager (DMM).</p>
Development board for STM32F processors with TSSOP20 package. All GPIOs are broken out to pins. The PA11, PA12 pins are connected to the USB connector via jumpers so the GPIOs can be used as standard GPIOs.
The SWD pins are broken out for easy flashing and debugging.
Tested on STM32F042F6 but as many STM processors have the same or quite similar pinout, it can be used for other MC...
Description available in Bahasa Indonesia
* **Compact & powerful**, 58.42x40.64mm (2300x1600mil) dengan MCU+RTC+uSD+BMS onboard.
* **2x18P pinout layout**, pitch 2.54mm (100mil), dengan susunan 1 sisi untuk peripheral (power, programming, communication) dan 1 sisi untuk GPIO, mempermudah manajemen jalur/kabel yang akan digunakan.
* **Castellated holes & pin header**, pilihan koneksi untuk mem...
## Original from r3bers (https://easyeda.com/r3bers/STM32F103C8T6-Test-Board) ##
> Board for STM32F103C8. Modified Power and Diode for USB and pullup for USB.
> Wiki https://wiki.stm32duino.com/index.php?title=Blue_Pill
> ![Generic STM32F103 PINOUT DIAGRAM](https://solovjov.net/reblag.dk/The-Generic-STM32F103-Pinout-Diagram.jpg)
## My mo...
Small development board for using an ATtiny44A or similar 14-pin ATtiny in SMD package on a breadboard.
Minimal hardware design featuring only MCU, breadboard friendly headers with extra power lines, ISP header for serial programming and reset button.
Uses bare chip and limited extra components.
Also usable for ATtiny84, ATtiny441 and ATtiny841.
Narrow form factor development board for ATtiny85, ATtiny45 and ATtiny13A.
Minimal hardware design featuring only MCU, breadboard friendly headers with extra power lines, ICSP header for serial programming and reset button.
Our website uses essential cookies to help us ensure that it is working as expected, and uses optional analytics cookies to offer you a better browsing experience. To find out more, read our Cookie Notice