Panoramic photo robot with Bluetooth control, based on Arduino MEGA 2560
Since everything in this schematic is either public or super simple I leave it as public too.
**NOT for commercial use!**
This project of mine has just been started so there is no firmware nor software (PC, Android) available yet. Currently I don't plan to make it public like the Arduino shield design.
If you like the s...
<p>Adjustable power suply for mini drill</p>
<p>This is a Drill or mini Drill adjustable power supply that enable your drill to have fine tune velocity control.</p>
<li>This board was tested from 5 up to 36v.</li>
<li>This board was designed to support the three main packages used for LM2576-ADJ. Do not install more than one LM2576 CI on the same board.</li>
PCB files for Adafruit DC Stepper Motor FeatherWing
Format is EagleCAD schematic and board layout
For more details, check out the product page at
Adafruit invests time and resources providing this open source design, please support Adafruit and open-source hardware by purchasing products from Adafruit!
Designed by Adafruit Industries.
This PCB has been designed for evaluatiuon of the DRV 10970 Brushless Motor Driver with Hall Sensors. The board allows to set configuration inputs to low, high or floating (DAA and CMTMOD) using resistors.
Demonstrating simulations of a DC and a two phase stepper motor.
#### Model of a generic DC motor.
The model has the motor positive and negative power supply terminals.
It also has three outputs.
TORQUE is a voltage representing the motor torque scaled as 1V/Nm.
ANGVEL is a voltage representing the angular velocity of the motor scaled as 1V/RADIAN/s.
POSITION is a voltage...
This is a microcontroller-driven bi-directional DC motor driver board with two input knobs.
The microcontroller is an ATtiny, it regulates the motor driver IC with PWM. The board requires only a single power source, with voltages from 9V upto 14V, depending on the motor requirements. The two input knobs can be read by the microcontroller ADC to control e.g. speed and timing.
The motor load can b...