This is a PCB for a custom personality chip and is designed to be used with droids from the Droid Depot at Galaxy's Edge. This project uses a single 8-pin SPI flash memory chip to store data. The PCB designs allow for both DIP-8 and SOP-8 (150-208mil) package SPI Flash memory chips.
While any 25 series 8-pin SPI flash memory chip should work, confirmed compatible chips include the following:
This schematic has a few functions to this circuit. This circuit takes voltages starting from 4V to a max. of 13V. It was an open source project I found online. I've redone this board's schematic. But when it came to de PCB design I kinda lost it. I got as close to sorting the components on the board, but I didn't know where to start connecting wires or how. I'm taking a little break, but if anyon...
This is a custom - Arduino uno - based circuit.
- Microcontroller: Atmel ATMega328p
- Bluetooth Module: Support HC-06 & HC-05
- Motor Driver IC: Two L293D (up to 4 DC motors or up to 2 stepper motors)
- Servo motor header
- 3 input/output pins (Can be used to connect LEDs or button SWs)
- Programmable header
- Reset button