Breakout board for ADAFRUIT Feather based on MCP2515 CAN controller with an 3.3V CAN transceiver.
This board also connects the various interrupt lines to the Feather to allow for better communication performance especially at higher CAN bus bitrates at the tradeoff that a couple of IO pins are occupied by the CAN FeatherWing. I added 0R resistor bridges into each interrupt line. So if interrupt c...
Schematic to test CAN bus (Controller area network) between Jetson TX2 and STM32.
Setting up the Controller Area Network (CAN) at: [https://lince-facens.github.io/mobilelab/setting-up/can-bus/](https://lince-facens.github.io/mobilelab/setting-up/can-bus/)